There are many people who have purchased a laser cutting machine, completely do not know how to install, how use, although the
laser cutting machine manufacturers will after-sales service engineers to install, but mastering some basic knowledge points will help the later maintenance and use of equipment. Today, to share the steps I installed laser cutting machine.
1. Fixed machine
Ensure that the machine has a relatively smooth state when working. After the arrival of our equipment, the machine is placed in a relatively smooth place, the first four wheels of the machine as well as the foot cups fixed.
2. Connect the cooling system
First, connect the water outlet OUTLET of the chiller to the water inlet, one by one. Then connect the water protection signal line and power line, and turn on the water protection switch.
3. Connect the air pump
Many people do not understand why you need to connect the air pump, in fact, when the laser cutting machine really work will produce a lot of powder attached to the material, affecting the effect of engraving or cutting, so we need to use an air pump or air compressor with a larger blowing volume to blow off the surface layer of the material powder.
4. Connect the extractor fan
As mentioned above, the machine will produce a lot of powder and smoke when working, the air pump will blow away the layer of powder on the surface of the material, and the role of the extractor fan is to suck away the powder and smoke to ensure the neatness of the machine and the material.
5. Connect the power cord
When the above steps have been completed, it is now time to connect our power cord. Plug the standard power cord into the place marked on the picture, and plug the other end into the power strip.
Unlock the emergency switch
The emergency switch of the unused machine is locked, please unlock the advanced switch before you want to start the machine. Here, you just need to turn it gently.
7. Start the machine
Here, we can go to the start-up procedure. For safety reasons, we need to turn on the main power first, and then turn on the laser power. 8.
Connect the machine to the computer with the USB cable
This way, the machine will be connected to the computer, so you can use the computer to transfer files when you need to process.
9. Turn off the machine
Finally, after using the machine, in order to maintain the machine or save electricity. We need to turn off the machine to form a good habit. Just the opposite of the steps to turn on the machine, first turn off the laser power, and then turn off the main power.
https://www.fiberlasercuttingmachiness.com/
